Lesvos Electronic

12V 2A DC 24W Regulated Switching Power Supply

Input: AC110-240V 50/60Hz
Output: DC 12V / 2A (Adjustable 10Volt - 15Volt)
Approvals: 3C/FC/ CE
100% full load burn-in test
Protections: overload/ over voltage/ short circuit
Cooling by free air convection
Weight: 159g
Size: 85 x 57 x 37(mm)
3.3 x 2.2 x 1.5(inch)

Limiter

Audio input: impedance 20 kOhm, optional preemphasis
Output voltage: 0,4 V rms
Dynamic range: >50 dB
Supply voltage: 15-18 V
Supply currents: 20 mA

Γεννήτρια Στέρεο

Supply voltage: 12-15 V (stabilized)

Quiescent supply current 12V/34mA

Audio 19 kHz rejection: 40dB

Channel separation at 1 kHz: > 55dB

Subcarrier rejection: > 60 dB

Pilot sampling frequency: 1.843 MHz (19kHz x 97)

Subcarrier sampling frequency: 1.843 MHz (38 kHz x 48.5)

Pilot sync. output: TTL

Max. audio input voltage: 5 V pp (1.75V rms)

Pilot tone level: linear adjustable 0-0.5V pp

Output voltage gain: linear adjustable 0-1.5

Audio input impedance: 2000 ohm

RDS input impedance: 1000 ohm

MPX output impedance: 500 ohm

Pilot sync. output impedance: 10000 ohm

Signal-to-noise ratio: > 70dB

Lesvos Electronic

Antenna OMB 87,5-108 MHZ

Maximum power 800 Watt

Antenna OMB 87,5-108 MHZ

Antenna OMB 87,5-108 MHZ

Maximum power 800 Watt

Antenna FM YAGI 3 Element 87,5-108 MHZ

Antenna OMB 87,5-108 MHZ

Antenna FM YAGI 3 Element 87,5-108 MHZ

Gain: 6 dB
Maximum power 800 Watt

Variable RF Coil

Variable Capacitor

10 - 380pF
Each 0 - 90pF

Variable RF Coil

0- 206uH
Diameter of wire: 2,2mm

Variable RF Coil

0 - 85uH
Diameter: 23.5cm
Total height including legs: 47cm
Total height of the coil: 40cm
Diameter of copper: 6.5mm
30 Turns

Variable RF Coil

Variable Capacitor

Stereo Coder

Variable Capacitor

10 - 480pF

Variable Capacitor

Limiter

12V 2A DC 24W Regulated Switching Power Supply

Audio/Speech Processor

Audio/Speech Processor, with microphone input available
Power: DC 12V, 30mA
If needed the board supplies 5v for the operation of a microphone.

Audio/Speech Processor

Audio/Speech Processor

Audio/Speech Processor, with microphone input available
Power: DC 12V, 30mA
If needed the board supplies 5v for the operation of a microphone.